Fuel Hoses, Found

[Bob Valentine <bob@tecmark.com>]

Finally found a local shop which stocks the whole Aeroquip line, not just
the metal-braid race stuff.   Not sure if anyone needs this info , but
here's pn's for what I used for going from frame-rail steel fuel line to
the fuel rail.  This is push-on rubber hose, no crimping rings or
compression fittings needed.  Rated for 300 psi.  Fittings are brass.  Also
available in -8 and -10.  

Hose, -6, Aeroquip PN 2556-6    
-6 Hose to Male 3/8" inverted flare fitting PN 4740-6
-6 Hose to Female 3/8" inverted flare fitting PN 4743-6

This is great stuff, and cheap too - hose $2.50/ft, fittings $3.25 each.  

-> Bob Valentine
-> bob@tecmark.com


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org