Re: Ported MAF

[WEG1192@aol.com]

In a message dated 08/12/2000 11:30:37 AM Eastern Daylight Time, 
amattei@mindspring.com writes:

<< Ported MAF >>

Anyone considered installing two stock MAF sensors in parallel side by side 
and then multiplying the gms/sec numbers by two in the ECM calcualtions? 
Would this work to give you more airflow at less pressure drop? All you would 
have to do is make sure the air split was done right to give equal pressure 
drop through each one. Leave one MAF connected to the ECM as normal and the 
other unconnected as a dummy sensor.
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org