Re: acceleration stumble

[chetwagner@uswest.net]

Well, I would do what you suggested except for the fact that it is 
running off the stock distrib(hall switch triggering coil).  I just about 
have my ignition module conversion done so I can do some timing 
work.

On 8 Sep 2000, at 16:37, Bruce Plecan wrote:

> 
> Try taking a little more timing out as you ramp to the 100K/Pa side of the
> table
> 4's can get really testy on ignition curves at *times*
> Bruce
> 
> 
> 
> 
> <<  I have changed everything relating to the accel enrich
>  functions, but nothing helps.  The only thing keeping my from
>  running this code in my conversion, so any insight into this problem
>  would be greatly appreciated.  BTW, I am using it in a 1.7L 4 cyl
>  engine with port injection.
>  --------------------------------------------- >>
> 
> I had problems in my GN with tip in stumble and the fix was to play in the
> AE
> vs temp multiplers. Might wanna take a peek in there and see if anything
> helps
> 
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Jim  (FA) Testa                                             TType86 on
> #BuickGN
> ASE Master Technician                                buick.fiendish.net:6667
> L1 Advanced Engine Performance                    NJ Lic MV Inspector
> jtesta1966@aol.com                           NJ Lic Emission Repair Tech
> http://members.aol.com/jtesta1966/buick.htm
> Associate Sponsor, Buicks at Bristol (RCA/JTP)
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> 
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> 
> 


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org